specification model lpv-60-5 lpv-60-12 lpv-60-15 lpv-60-24 lpv-60-36 lp v-60-48 dc voltage rated current current range rated power output line regulation load regulation setup, rise time note.6 hold up time (typ.) voltage range note.4 frequency range efficiency (typ.) ac current (typ.) input inrush current(max.) leakage current safety standards working temp. working humidity storage temp., humidity temp. coefficient vibration mtbf dimension others note packing over current over voltage 5v 12v 15v 24v 36v 48v 8a 5a 4a 2.5a 1.67a 1.25a 0 ~ 8a 0 ~ 5a 0 ~ 4a 0 ~ 2.5a 0 ~ 1.67a 0 ~ 1.25a 40w 60w 60w 60w 60w 60w 80mvp-p 120mvp-p 120mvp-p 150mvp-p 150mvp-p 150mvp-p 8.0% 1.0% 6.0% 90 ~ 264vac 127 ~ 370vdc 47 ~ 63hz 76% 83% 2.0% 5.0% 83% 86% 86% 86% 5.75 ~ 6.75v 13.8 ~ 16.2v 17.25 ~ 20.25v 27.6 ~ 32.4v 41.4 ~ 48.6v 55.2 ~ 64.8v 1.2a/115vac 1a/230vac cold start 30a/115vac 60a/230vac 0.25ma / 240vac 110 ~ 150% rated output power protection type : hiccup mode, recovers automatically after fault con dition is removed compliance to en55022 (cispr22) class b, en61000-3-2 class a, en610 00-3-3 compliance to en61000-4-2,3,4,5,6,8,11, en55024, light indust ry level, criteria a -30 ~ +70 (refer to "derating curve") 20 ~ 90% rh non-condensing -40 ~ +80 , 10 ~ 95% rh 0.03%/ (0 ~ 50 ) 10 ~ 500hz, 2g 10min./1cycle, period for 60min. each along x, y, z axes ul879, ul1310 class 2(except for lpv-60-5), can/csa c22.2 no. 223-m9 1(except for lpv-60-5,lpv-60-48), ip67 approved ; design refer to tu v en60950-1, en61347-2-13 732khrs min. mil-hdbk-217f (25 ) 162.5*42.5*32mm (l*w*h) 1. all parameters not specially mentioned are measured at 230vac input, r ated load and 25 of ambient temperature. 2. ripple & noise are measured at 20mhz of bandwidth by using a 12" twisted pair- wire terminated with a 0.1uf & 47uf parallel capacitor. 3. tolerance : includes set up tolerance, line regulation and load regula tion. 4. derating may be needed under low input voltage. please check the static ch aracteristics for more details. 5. the power supply is considered as a component that will be operated in comb ination with final equipment. since emc performance will be affected by t he complete installation, the final equipment manufacturers must re- qualify emc directive on the complete installation again. 6. length of set up time is measured at first cold start. turning on/off the pow er supply may lead to increase of the set up time. 7. in the european market this product is only suitable for led lighting appl ications that don't have to comply with the harmonic current requiremen ts of en61000-3-2 class c. 8. suitable for indoor use or outdoor use without direct sunlight exposur e. please avoid immerse in the water over 30 minute. 0.4kg; 32pcs/13.8kg/0.56cuft protection type : shut down o/p voltage, re-power on to recover 60w single output switching power supply features : l p v- 6 0 s e r i e s ripple & noise (max.) note.2 voltage tolerance note.3 environment safety & emc protection withstand voltage isolation resistance i/p-o/p:3kvac i/p-o/p:>100m ohms / 500vdc / 25 / 70% rh file name:lpv-60-spec 2011-06-24 constant voltage designuniversal ac input / full range withstand 300vac surge input for 5 seconds protections: short circuit / over current / over voltage cooling by free air convection fully encapsulated with ip67 level ass lps suitable for led lighting and moving sign applications100% full load burn-in test low cost, high reliability 2 years warranty (note.8) fully isolated plastic case class power unit, no fg p (note.7) 500ms, 20ms / 230vac 5 at full load ; 00ms, 20ms / 115vac (for 5~36v) 500ms, 30ms / 230vac 500ms, 30ms / 115vac at ful l load(for 48v) 50ms/230vac 16ms/115vac at full load ip67 lps ( for 48v only) ( except for 5v,48v ) emc immunity emc emission
mechanical specification file name:lpv-60-spec 2011-06-24 fosc : 65khz pwm o.l.p. emi filter rectifiers power switching filter & rectifiers +v -v i/p control & block diagram +v(red) -v(black) 600 30 3.6 3.6 162.5 3.5 3.5 3.5 3.5 42.5 600 30 32 detection circuit o.v.p. 230vac 115vac ac/n(blue) ac/l(brown) recommend mounting direction t case: max. case temperature. 81.5 t case 15 ul1007 16awg ul1015 18awg load (%) 20 40 60 80 100 input voltage (v) 60hz 90 100 125 135 145 155 165 175 180 200 230 264 100 90 80 70 60 50 40 load (%) derating curve load (%) derating curve static characteristics ambient temperature ( ) load (%) 175 load (%) 60w single output switching power supply l p v- 6 0 s e r i e s (horizontal) -15 0 15 30 0 40 50 -30 60 70 case no. 976a unit:mm
|
